But let's see what the above does for you. do they? will turn off the power and all 4 lights will go off. As soon as you enter, all 4 lights on the motorboard should light. You probably already know this too, but I just want to make sure you know all DCC++ commands are entered with these brackets around them. Next, Enter "", so a less than symbol, 1 and greater than symbol. Does that work? You can turn off power connect pin A5 to ground, reboot and get more information from the serial monitor to check all your settings. When you connect with the serial monitor, you should immediately see the boot information with your Arduino type, the motor board name and the software version. You probably already have the correct com port and baud rate of 115200. Use a serial monitor like the one in the Arduino IDE. What voltage are you using? Did you cut the trace on the motorboard "Vin Connect" if you are using more than 12V to the motor shield? Do you have a 5V power suppy on the Uno and another one connected to the motorboard?Īre your jumpers set with one connecting pins 13 and 5 and another connecting 10 and 12? See here: How did you upload the sketch? Did you use the Arduino IDE or our Installer?ĭid you make any changes to the config.h file? MOTOR_SHIELD_TYPE and COMM_INTERFACE should both be "0" First let's test the hardware setup to see if it is responding. On the practical side, no power on/off to track/prog on motor shield, so no loco controls at all.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |